A new first motion shaft bearing installed.
First motion shaft in place with new gasket. Not so fast, we need some new shims for the front cover. We will revisit this part in a few days.
Third motion shaft, with new needle bearing and synchro rings installed, and laygear in place.
Selector rods installed with new safety wire on the first/second gear selector.
Laygear shaft in place with thrust washers and new needle bearings. Reverse gear in place.
Speedometer drive in place with new gasket and a bit of form a gasket as well.
Output shaft torqued and lock tabbed.
That once dirty mess is now a refreshed transmission. When I get the shims the front cover will go on and it will be done.
No comments:
Post a Comment