The time has come to finish putting the transmission together. I have all the new parts I need, the clutch release fork has a new bushing installed along with a new bolt and nut.
Oh, wait a minute, that is a crack in the front cover.
You can see the crack on the outside as well when you know where to look.
It took a bit but I finally got a new cover and seal.
New seal installed.
Re-gap the front cover to the new first motion shaft bearing, good to go.
Cover installed and release fork and new rubber boot in place. All is well with the transmission now. The fly wheel has been resurfaced and the new clutch is ready as well. Now I just need to finish the engine so I can put this all together.
No comments:
Post a Comment