 |
| Dogleg panel prepped and ready to go on. |
 |
| Tack welded in place. |
 |
| The trailing edge is straightened since the panel did not fit with the rounded end, I just pounded it flat on an anvil. |
 |
| The wheel well was reinforced to withstand pounding the trailing edge around to fit the contour. |
 |
| After finishing all the welding, the welds are ground smooth. Job done. It took a couple of hours to fit the dogleg panel to the car, but the attention to detail was worth it as it made butt welding the panel very easy since there were no gaps. |
No comments:
Post a Comment